Bus T3 - clutch master cyclinder and clutch slave cylinder
Novelties
No results were found for the filter!
NEW
in stock
Clutch hose, 325 mm, fits for Bus T3
Clutch hose 325 mm fits for: Bus T3, 1.6-2.1 (incl. D), 05/79-07/92 for vehicles with hydraulic clutch actuation
NEW
Clutch pressure pipe, rear, fits for Bus T3
Pre-bent coupling tube for the early gasoline versions ready for installation Made from tubular steel 300 mm rear fits for: Bus T3, 1.9, 08/82-02/85
Clutch pressure pipe, two-piece, fits for Bus T3
Clutch pressure pipe two-piece fits for: Bus T3 After mounting the front longer part over the tank, the rear third is pushed through the cross member and simply bolted to the front. The tubes are ready made, no further material is...
NEW
in stock
Clutch pressure tube, rear, fits for Bus T3
Pre-bent coupling tube for the early gasoline versions ready for installation Made from tubular steel 250 mm rear fits for: Bus T3, 1.6/2.0, 05/79-12/82
in stock
Coupling tube midway between the master and slave clutch cylinder
Coupling tube midway between the master and slave clutch cylinder fits for: Bus T3, 1.6-2.1 (incl, D), 05/79-07/92
in stock
Grommet. Various Applications, 23.5/6mm
this seal is fixed with nearly each vehicle e.g.: Beetle: where the fuel flexi pipe meets the body Bus T2: carrying out the fuel pipe Bus T3: carrying out the hydraulic line Made by WERK34
in stock
in stock
Viewed