Bus T2 - engine
Novelties
No results were found for the filter!
Pair of shielding plates, fits for single channel preheating
type 1 engines 1200 to 1600ccm with single preheating fits for Beetle (from engine no. 7 336 420) Bus T1 (from engine no. 5 000 001) Karmann Ghia (from engine no. 7 336 420) Type 147 (from engine no. 7 336 420) Bus T2 Type 181 Since this...
in stock
Paper gasket for flywheel, fits different models
fits for Bus T1 (34 hp from 11/64) Beetle (34 hp (from 08/66) Thing type 181 Bus T2 (1.6 engine) original spare part, NOS
in stock
Pilot shaft bearing
This bearing is located in the flywheel bolt of a type 1, type 3 and CT/CZ engine and in the crankshaft of a type 4, WBX and diesel engine. It is advisable to always replace this bearing when you are going to replace the clutch disc and...
in stock
Piston and cylinder set, cast, fits for Bus T2 + T3
Piston and cylinder set cast Bore: 94 mm Stroke: 71 mm Diameter 1: 105 mm (top) diameter 2: 100 mm (bottom) fits for: Bus T2, 2.0, 08/75-07/79 Bus T3, 2.0, 05/79-04/86
in stock
Piston Ring Set (for all 4 pistons) 94mm Standardmaß, fit for 2,0 Typ 4
passend für VW Bus T2 und T3 2,0 L 94 mm 1,75x4,05x2,00
in stock
Piston Ring Set, Cast Top Ring, 87 mm
Piston Ring Set 87 mm suitable for Karmann Ghia 01/70-07/74, 1.6 Bus T2 08/67-07/79, 1.6 Type 1 01/70-12/79, 1.6 181 Thing 08/70-02/79, 1.6
in stock
Piston Ring Set, Cast Top Ring, 92 mm
Piston Ring Set 92 mm suitable for 181 Thing 09/69-02/79, 1.5-1.6 Karmann Ghia 08/61-07/74, 1.3-1.6 Bus T2 08/67-07/79, 1.6 Type 1 01/65-07/75, 1.3 Type 1 04/70-12/79, 1.6
in stock
Piston Rod Bearing 18/22 kW (25/30 PS) 8 Piece 0,50
18-22 kW (25-30 PS) 0,50 mm suitable for Beetle Bus T1 Bus T2 Karmann Ghia Type 14 Karmann Ghia Type 34 181 Thing Type 3 Fridolin 147
in stock
Piston Rod Bearing 25-37 kW (34-50 PS) 1,2/1,6 + WBX 8 Piece
25-37 kW (34-50 PS) 1,2/1,6 WBX 8 Piece
in stock
Piston Rod Bearing 25-37 kW (34-50 PS) 1,2/1,6 + WBX, 8 Piece
25-37 kW (34-50 PS) 1,2/1,6 WBX 8 Piece
in stock
Pistons and Cylinder, not forged, 87 x 69, 1641 ccm
Alle Sätze bestehen aus 4 Zylindern, 4 Kolben mit Kolbenbolzen und Kolbenringen.
in stock
Pivot pin for clutch, fits various models
for the following clutches 111 141 025 C, 111 141 025 D, 111 141 025 F, 111 141 025 G, 111 141 025 H, 113 141 025, 113 141 025 A, 211 141 025 A, 211 141 025 C, 211 141 025 D, 311 141 025 & 311 141 025 B 3 pieces needed per vehicle...
in stock
Plugs for OE fan shroud, 48 mm
Plugs for OE fan shroud 48 mm fits for 181 Thing 09/69-02/79, 1.5-1.6 Karmann Ghia 08/55- 07/74, 1.2-1.6 Bus T1 01/50-07/67, 1.2-1.5 Bus T2 08/67-07/79, 1.6 Type 1 12/47-12/85, 1.2-1.6
in stock
Pressure plate mounting kit, heavy duty, fits air-cooled engines
M8 x 20, property class 10.9, width across flats 13 fits for Beetle Karmann Ghia type 14 Type 147 Type 181 Bus T1 Bus T2 (not for 215mm clutch) Type 3 Karmann Ghia Type 34 Type 4
in stock
Pressure plate mounting screw, heavy duty, fits for 215mm clutch
only for 215mm clutch; except diesel M7 x 20, property class 12.9, hexagon socket 6 fits for Bus T2 (engine code AP, AS & AF) Bus T3 (engine code CT & CZ) Type 4 (until engine no. W 0 129 581 & Z 0 017 418) 6 needed per vehicle. As a...
Pressure plate, 200 mm, suitable for models from year 08/70 and bus up to year 02/76
suitable for: Beetle Bus
in stock
Protective cap for fuel pump connection, fits Bus (from 08/74)
for vehicles with injection system fits for Bus T2 (from VIN 215 2000 001) Bus T3 (engine code CV) original spare part, NOS only few available
in stock
Pulley shaft seal
This shaft seal was not originally installed and can be used if oil leaks from the pulley. In most cases, this can prevent complete disassembly of the engine and stop the oil loss.
in stock
Pulley shaft seal kit
This pulley shaft seal kit was not originally installed and can be used if oil leaks from the pulley. In most cases, this will prevent the engine from being completely disassembled and stop the oil leakage. This kit is consisting of...
in stock
Push rod of fuel pump, fits type 1 engine (06/59 to 07/80)
length 108mm made in Germany fits for Beetle (from 34HP) Karmann Ghia (from 34HP) Type 147 (from 34HP) Bus T1 (from engine no. 3 400 000) Bus T2 (up to VIN 211 2300 000) Type 3 Type 34 Typ 181
in stock
Push rod of fuel pump, fits type 1 engines (from 08/73)
length 100mm for vehicles with alternator fits for Beetle Karmann Ghia Type 147 Bus T2 (from VIN 212 000 001)
in stock
Push Rod Tube 208mm, fit for T2 1.7-2.0
914/4 All 08/69-07/76 VW T.2 1.7-1.8 08/71-07/75 VW T.2 2.0 08/75-12/82
Push rod tube set, with seals
Push rod tube set with seals aluminium Set of 8 leak-proof fits for 181 Thing 09/69-02/79, 1.5-1.6 Karmann Ghia 08/65-07/74, 1.5-1.6 Bus T1 08/65-07/67, 1.5 Bus T2 08/67-07/79, 1.3-1.6 Type 1 08/65-12/79, 1.3-1.6 Type 3 08/65-07/73,...
in stock
Race cooling fan, welded, 34,7 mm
Race cooling fan welded 34,7 mm fits for 181 Thing 08/70-07/73, 1.6 (AG) Karmann Ghia 08/70-07/74, 1.3-1.6 Bus T2 07/71-07/79, 1.6 Type 1 08/70-12/85, 1.2-1.6
in stock
Rear Engine Tin Ware, T2 08/71-07/79 for all 1,6 l
Rear engine tinware for August 71 onwards Baywindow with fixed rear valance. This is to fit a 1600cc engine in a Baywindow. This is a new reproduction having not been available new in Metal for a long time.
in stock
Recirculation shut-off valve 12 volts
Bitte wählen Sie oben aus zwischen dem Ventil für einen 30 oder 34 PICT Vergaser.
in stock
Reduzierstück für Luftfilter, passend für Bus T2 (08/71 bis 07/72)
passend für Bus T2 (bis Motor-Nr. CA 017 215) Original-Ersatzteil, NOS wenige verfügbar Ersatzteilnummer zum Vergleich: 021 129 638 wurde später durch 055 129 638 ersetzt, ist aber auch stattdessen
in stock
Reglerkasten des Luftfilters, passend für Bus T2
passend für Bus T2 (mit Typ 4-Motor) Original-Ersatzteil, NOS Einzelstück
in stock
Repair socket for spark plug thread in the cylinder head
Repair bushing for spark plug thread in cylinder head fits for: Beetle Karmann Ghia Type 14 Karmann Ghia Type 34 Bus T1 Bus T2 Type 3 Fridolin type 147 Bucket car Type1 with short thread
in stock
Retaining ring for automatic choke, fit for Type 3/34, Type 4 & Bus T2
fits for: Type 3/34 Type 4 (carburetor models) Bus T2 (1700 cc) Originalsparepart only few available
in stock
Return spring for clutch cover, fits various models (from 08/70)
for clutch cover 311 141 025 D, marked 311 141 025 A/B/C/D installed in Beetle (engine code AD, AE AF & AH) Karmann Ghia (engine code AD, AE AF & AH) Type 3 (from engine no. K 0 173 003 & T 0 805 014) Bus T2 (engine code AB, AD, AE & AF)...
in stock
in stock
Right Hand Under Cylinder Tinware
NOS with some small scratches Original part number serves only for comparsion: 021 119 356 E
Viewed