Golf MK I - Front Axle
Novelties
No results were found for the filter!
in stock
in stock
Ball Joint for Wishbone, 17 mm, fits for Golf MK1
fits for: Golf + Jetta, 1.1-1.8 (also Diesel), years 12/77-07/83 Golf MK1 Cabrio, all years Porsche 924, years 08/76-07/85 Porsche 944, years until 01/85
in stock
in stock
Bush, Front wishbone
fits for: Golf + Jetta, 1.1-1.8 (also Diesel), years 02/74-07/83 Golf MK1 Cabrio, all
in stock
Bush, Rear, Front Wishbone
fits for: Golf, 1.1-1.8 (also Diesel), years 02/74-07/83 Jetta, 1.1-1.8 (also Diesel), years 02/74-07/83 Golf MK1 Cabrio, all years
in stock
Bushes and mounting Kit,Stainles Steel, for front anti-roll-bar, fit Golf MK1
Set consisting of: 2x clamp for stabilizer inside, stainless steel 2x clamp for stabilizer outside, stainless steel 2x rubber bearing stabilizer inside 2x rubber bearing stabilizer outside 6x nut 6x washer fits for Golf I, Jetta I, Caddy...
in stock
Castle nut for tie rod end, fits for all models from 68
M 12 x 1,5 fits for Type 1 (from VIN 118 857 240) Type 14 & 147 (from VIN 148 857 240) Type 181 Bus T2 & T3 Type 3 & 34 Type 4 K 70 LT (1. generation) Golf MK1 Jetta MK1 Caddy MK1 Scirocco MK1 original quality
in stock
Cup spring for wishbone
Cup spring for wishbone fits for Beetle (1999 - 2012) Beetle Convertible (2003 - 2010) Bora (1999 - 2005) Caddy (1983 - 2011) Corrado (1989 - 1995) Eos (2006 - 2011) Golf (1975 - 1998) Golf Convertible (1979 - 2012) Golf Variant (1998 -...
in stock
Eccentric Bolt for Front Strut Housing, fit for Golf MK1
fits for: Caddy, 83-92 Golf MK1, 75-84 Golf MK1 Cabrio, 79-93 Jetta MK1, 79-84 Scirocco MK1 + MK2, 74-92
in stock
Excentric Washer, priced each
Eccentric disc for front suspension strut attachment fits for both sides fits for: Caddy I Golf I Jetta I Scirocco I+II
in stock
in stock
Fixing Kit for Front Suspension, fit for Golf MK1
Set Including Eccentric Screw Screw 2x Washer Eccentric Washer 2x Nut
in stock
Flange Cup Seal
fits for: Golf MK1, MK2, MK3 and MK4 Jetta MK1 and MK2 Vento Polo 6N Passat Beetle Karmann Ghia Tubing 181 Bus T4
in stock
Front Anti Roll Bar (ARB) Outer Rubber Mounting, fit for Golf MK1
fits for: Golf/Jetta, 1.6-1.8, 06/76-02/84
Front Anti Roll Bar Inner Top Clamp, fits for Golf MK1
fits for: Golf/Jetta Golf MK1 Cabrio, 1979-1993 Golf MK1, 1975-1983 Scirocco, 1974-1992 Jetta, 1980-1983
in stock
Front anti-rollbar top clamp, stainless steel
fits for all Golf I, Caddy I and Golf I cabrio material: stainless steel including 2 nuts and 2 washers made by WERK34 !ATTENTION: the price stated below is the unit price of the article!
in stock
Front axle cross brace X-Frame
Front axle cross brace X-Frame With our front axle cross brace, the front and rear wishbone points are connected to one another. This creates an additional rigidity of the frame which has a positive effect on the driving characteristics...
in stock
Front Inner Anti Roll Bar Mounting Bush, fits for Golf + Jetta
fits for: Golf/Jetta, 1.6-1.8, 06/76-02/84
in stock
Front Shock Absorber Serie, fits for Golf MK1
fits for: Golf MK1 + Jetta MK1 year 02/74-07/83 Engine 1.1-1.8 incl. Diesel
in stock
Front Strut Top mount, Golf Mk1
fit for Golf + Jetta 1.1-1.8 years 06/77-07/83 Golf I Cabrio all years
in stock
Front suspension bump stop, fits for Golf MK1
front suspension bump stop fits for: Golf MK1 Jetta MK1 Scirocco MK1 made by WERK34
in stock
in stock
Lower Clamp, front inner anti roll-bar bush, stainless Steel, Golf MK1/Jetta
can be installed on the right or left unit price fits for: Golf MK1 + Convertible Scirocco MK1 + MK2 Jetta MK1 Caddy MK1
in stock
Mounting cut, front, fits for Beetle 1302 / 1303, Golf MK1, Passat B1
Mounting cut front fits for Beetle 1302/1303 (08/70 - 01/80) Golf MK1 (02/74 - 07/78) Passat B1 (05/73 - 11/80) 411 / 412 (08/68 - 07/74) Scirocco (02/74 - 07/78) Original part number for comparison: 823 412 323
in stock
Nut (self-locking) for drive shaft
fits for: Golf/Jetta, 1.0-1.8 (incl. D), 02/74-10/91 Golf/Vento, 1.4-2.0 (incl. D), 11/91-09/97 Golf/Vento Automatik, 2.0, 11/91-05/96 Passat, 1.5-1.9D, 08/77-09/96 Passat/Santana, 1.3-2.2, 06/74-09/96 Polo/Derby, 0.8-1.4 (incl. D),...
in stock
in stock
in stock
in stock
in stock
in stock
Pair of racing sports docks with camber adjustment for Golf I + Cabrio
Raceport-Domlager for VW Golf I front 2 pieces Note: They are for camber adjustment of + 3Grad / 0Grad / -3Grad The screws are longer than the originals, so you can mount a strut brace Mounting material included The Domlager fits...
in stock
Reinforcement plates
Do you like to go a little faster? Your car body is too "soft" for you? With our reinforcement plates you can additionally strengthen your dome. Thus you achieve a higher stiffness and better driving comfort. The sheet metal must be...
in stock
Rubber bearing for steering gear, right, only for vehicles with power steering
only for vehicles with power steering fits for RIGHT fits for the following vehicles: Golf MK1 Golf MK1 Cabrio, 1982-93 Jetta MK1 Scirocco MK1 + MK2, 1982-92
in stock
in stock
Screw M8x25
fits for: Caddy MK1, 10/82-07/92 Golf MK1, 08/78-02/84 Golf MK1 Cabrio, 08/78-07/93 Jetta MK1, 08/78-02/84 Passat B1, 05/73-11/80 Scirocco, 04/81-07/92
in stock
Sechskantschraube M8 x 20
Made in Germany !ACHTUNG: Bei dem unten angegebenen Preis handelt es sich um den Stückpreis des Artikels!
in stock
in stock
Series spring front axle, fits for Golf I from year of manufacture 1979
fits for: Golf I + Golf I Cabrio + Caddy I Eninge: 1.1-1.8 inkl. Diesel not for GTi all years from 07/79
in stock
Shock absorber with gas pressure shock absorber front, series, fit for Golf MK1
fits for: Golf MK1 + Jetta MK1, 02/74-07/83, 1.1-1.8 including diesel Golf MK1, all Complete strut
in stock
Spacer for strut top
fits for: Golf Cabrio, 1.5-1.8, 01/79-07/93 Golf/Jetta, 1.1-1.8 (incl. D), 05/77-02/83 Scirocco, 1.1-1.8, 06/77-07/92 Type 1 1303, 1.3-1.6, 08/73-04/79 Type 3, 1.5-1.6, 08/73-07/74
in stock
Spring Compressor, 1 Set = 2 pieces
Robust spring tensioner made of high quality steel´ Up to 1500kg load capacity Up to 300 mm clamping travel
in stock
in stock
in stock
in stock
Viewed