Fridolin Typ 147
Novelties
No results were found for the filter!
in stock
Core cover for camshaft housing, suitable for Type 1, 2, 4 and WBX
Core cover for camshaft housing suitable for Type 1 Type 2 Type 4 WBX
in stock
Cover plate for lower belt pulley
fits for original spare part, NOS few available Spare part numbers for comparison 111 119 551 B
in stock
Cover plate for lower pulley, fits models from 12/63 to 07/69
fits for Beetle, Karmann Ghia, Type 147 (engine no. 7 336 420 up to D 0 525 049, up to E 0 020 021, up to F 1 778 163, up to H 0 874 199, up to L 0 019 336) Bus T1 (from engine no. 7 336 420) original spare part, NOS few available spare...
in stock
Cover plates, swing axle
dieser Deckel entspricht dem original Teil original Teile Nummer dient nur zum Vergleich 111 511 255 C
in stock
Cover with integrated draining plug, for 22/39 kW (30/54PS) engines
with oil drain plug and gasket set fits for all type 1 engines from 34HP onwards Bus T1 (from 30HP, engine no. 3 999 999)
in stock
Cover with integrated draining screw 25/34kW (34-50 PS)
passend für alle 25 bis 37kW (34 bis 50 PS) Motoren
Crank Shaft, Serial, fit for 1300-1600 Typ1 Engines
fit for all 1.3 - 1.6 Typ 1 Engines for example Käfer, Bus, Typ3 etc. New Part (Kein Austausch) 69mm Hub Über Kreuz gebohrt
in stock
Crankshaft bearing no. 1, standard size, fits type 1 engines (from 05/60)
standard dimension 65,0 mm Ø outer dimension original spare part, NOS with storage traces few available
in stock
Crankshaft bearing no. 3, 1st undersize, fits type 1 engines (from 05/60)
not for 30 HP engines except Bus T1 (from engine no. 3 400 000) 0.25mm undersize (shaft) 65.0mm Ø outer dimension original spare part, NOS few available
in stock
Crankshaft bearing no. 3, 2nd undersize, fits type 1 engines (from 04/60)
not for 30 HP engines except Bus T1 (from engine no. 3 400 000) 0.50mm undersize (shaft) 65.0mm Ø outer dimension original spare part, NOS few available
in stock
Crankshaft bearing No. 3, 4th undersize, for type 1 engines (from 05/60)
not for 30 HP engines except Bus T1 (from engine no. 3 400 000) 1.00 undersize (shaft) 65.0 mm Ø outer dimension (standard) original spare part, NOS few available
in stock
Crankshaft bearing no. 4, 1st undersize, for type 1 engines (from 05/60)
not for 30 HP engines except Bus T1 (from engine no. 3 400 000) 0.25mm undersize (shaft) 50.0mm Ø outer dimension (standard size) original spare part, NOS not all in original box, not selectable few available
in stock
Crankshaft bearing no. 4, standard size, for type 1 engines (from 05/60)
not for 30 HP engines except Bus T1 (from engine no. 3 400 000) standard dimension (shaft) 50.5mm Ø outer dimension (1st housing oversize) original spare part, NOS not all in original box, not selectable few available
in stock
Cushion grip clutch disc, 200 mm
Due to the special lining mixture of organic material and sintered material which is located on both surface sides, a soft but not skidding engagement of the clutch is made possible.
in stock
CV boot with assembly items and grease
mit Schmierfett MOS2 und Befestigungsmaterial passend für 1302, 1303 und Automatik Käfer, Karmann Ghia und Typ 3 mit Schräglenkergetriebe oder Automatik original Qualität Hersteller Febi-Bilstein
in stock
Cylinder and piston kit 1192 cc (1200)
suitable for Type 1 engines Specifications Bore: 77 mm Stroke: 64 mm Case: 90 mm Cylinder head: 90 mm Piston pin: 20 mm
in stock
Cylinder and piston set diameter 1679ccm / 1600 slip-in
Bore: 88 mm Stroke: 69 mm Case Ø: 90 mm Cylinder head Ø: 94 mm Piston pin Ø: 22 mm If you want more power from your engine, there are many options. You can increase the engine power without changing the displacement by changing the...
in stock
Cylinder Bolt Top fits for engine 1.2 , 10 x 178 mm
to enable faster repair of a stripped or worn thread in the crankcase
in stock
Cylinder Bolt, top, fit for 1.5-1.6, 10x204mm
to enable faster repair of a stripped or worn thread in the crankcase
in stock
Cylinder coats (pair) for single port engine 1300, 1500 & 1600
Beetle, Bus, cylinder barrels and air deflector panels are always delivered in pairs.
Cylinder head nuts M10 (16 pieces), fit from 08/55
fit for Type 3 engines Type 4 engines Type 1 engines (from engine no. 1 120 615)
Cylinders and Pistons 1,6 85,5x69 Mahle
Each set consists of 4 cylinders, 4 pistons with gudgeon pins and piston rings. Piston sets and piston ring sets by request.
in stock
Cylinders and Pistons 22 kW (30 PS)
Bore 77mm / stroke 64mm / cylinder 83.90 above, 81.90 below / piston pin 20mm / 1192ccm Manufacturer Mahle Mahle is finally delivering pistons and cylinders for 30 HP engines again, and these engines have already been delivered from the...
NEW
in stock
Dachblinkleuchte "Micky Maus", passend für verschiedene Modelle
Hersteller HELLA für Leuchtmittel P21W (BA15s) Gehäuse Kunststoff Ø ca. 120mm Höhe insgesamt 135mm Befestigung M10
in stock
deflectorplate under generator support
original Ölabweisblech werden unter dem Lichtmaschinenfuß bei Typ 1 Motoren ab 1960 montiert Top Qualität
in stock
Dichtkegel 35mm für Auspuff, passend für Typ 1-Motoren (ab 08/55)
für Anschluss Wärmetauscher passend für Käfer (ab Motor-Nr. 3 949 223 und 7 336 420) Karmann Ghia, Typ 14 (ab Motor-Nr. 3 949 223 und 7 336 420) Bus T1 (ab Motor-Nr. 7 336 420) Bus T2 (bis 1600ccm) Typ 3 Typ 34 Typ 181 "Kübel" (1600er...
in stock
Dichtring am Radlager der Pendelachse, passend für verschiedene Modelle
25,5x2,6mm passend für Käfer Karmann Ghia Typ 147 "Fridolin" Bus T1 Typ 3 Typ 34 Typ 181 "Kübel" (bis FIN 183 2346 524) als Dichtring des Wasserablaufschlauchs der Frischluftregulierung Bus T2 als Dichtring am automatischen Trittbrett...
in stock
Dichtring für Stiftschrauben, passend für 34PS Motoren
für Stiftschrauben 113 101 397 passend für Käfer Bus T1 Karmann Ghia Typ 14 Typ 147 Original-Ersatzteil, NOS begrenzte Stückzahl
in stock
Dichtring für Stiftschrauben, passend für 34PS Motoren
für Stiftschrauben 113 101 397 passend für Käfer Bus T1 Karmann Ghia Typ 14 Typ 147 Original-Ersatzteil, NOS begrenzte Stückzahl
in stock
Dichtring für Stiftschrauben, passend für Typ 1-Motoren & WBX
für Stiftschrauben 113 101 399 B passend für Käfer, Karmann Ghia & Typ 147 (ab Motor-Nr. 9 205 700) Bus T1 (ab Motor-Nr. 710 800) Typ 3 & Type 34 (ab Motor-Nr. 672 698) Typ 181 Bus T2 Bus T3 (CT, CZ & WBX) Original-Ersatzteil, NOS...
in stock
Dichtring für Zylinderkopfmutter nur 18kw (25PS) bis Motornummer 3 399 999
es werden 8 Stück benötigt Länge: 20mm Breite: 20mm Höhe: 3mm
in stock
Dichtung 58x69,5 für Tankdeckel, passend für verschiedene Modelle (08/60 bis 01/74)
für Tankdeckel 343 201 551 passend für Käfer (FIN 3 192 507 bis 117 999 000) Karmann Ghia Typ 14 (FIN 3 192 507 bis 147 999 000) Typ 147 (bis FIN 147 999 000) Bus T2 (bis FIN 211 2300 000) Typ 3 (bis FIN 317 500 000) Karmann Ghia Typ 34...
NEW
Dichtung für Abgasrohr, passend für verschiedene Modelle
passend für Käfer Karmann Ghia Typ 14 Typ 147 "Fridolin" Bus T1 Bus T2 1600 Bus T3 (Mkb CT & CZ) Typ 181 "Kübel" Typ 3 Original-Ersatzteil, NOS begrenzte Stückzahl
Dichtung für Schaltgehäuse der Vollsynchrongetriebe
passend für Käfer (ab FIN 3 192 507 bis 112 3200 000) Käfer 1303 (bis FIN 133 2412 810) Karmann Ghia (ab FIN 3 192 507) Typ 147 Typ 181 Bus T1 (ab FIN 469 506) Typ 3 Typ 34 Original-Ersatzteil, NOS wenige vorhanden
in stock
Dirko HT sealing compound 70ml
Sealant Dirko HT (red) Permanently elastic silicone sealant, (temperature resistant from -50 ° C to + 280 ° C, short term + 315 ° C): Safe and universal sealing - even of moving parts. Whether surfaces, columns (up to approx. 2 mm) or...
Order number: 11586
Content 0.07 Liter (€232.86 * / 1 Liter)
€16.30 *
Prices incl. 19% VAT plus shipping costs
in stock
in stock
Disc brake knuckle, left, fits for 1303 from 08/73, used
Disc brake axle stub left fits for: 1303, from 08/73 used
Viewed