electrical
Novelties
No results were found for the filter!
in stock
Batterie 6Volt 66AH
Die Batterie im schwarzem Gehäuse ist trocken vorgeladen und wird unbefüllt geliefert! Oldie Look Für die Batterie wird 2,2 Liter Batteriesäure benötigt!
in stock
in stock
in stock
in stock
Battery Cover 240 x 170 mm
Please compare the measurements with your battery. 240 x 170 mm Made by WERK34
Bevel washer, starter, 6V
Bevel washer behind the starter pinion Bettle, Karmann Ghia 12/56-07/66 Bus T1 12/56-07/66 Type 3 12/56-07/66
in stock
Blower switch, 4-stage, fits various models (08/76 to 12/95)
Stage 0 - 3, four contact pins for vehicles without air conditioning fits for Golf Mk1 (from VIN 177 2000 001) Jetta Mk1 Golf Mk1 Convertible Golf Mk2 / Jetta Mk2 Scirocco Mk1 & Mk2 Caddy Mk1 LT 1st generation (from VIN 28 A 000 001)...
in stock
Blower switch, universal, fits various models (08/76 to 12/95)
stage 0 - 4, 5 contact pins for vehicles with air condition as well fits for Golf Mk1 (from VIN 177 2000 001) Jetta Mk1 Golf Mk1 convertible Golf Mk2 / Jetta Mk2 Scirocco Mk1 & Mk2 (from VIN 537 2000 001) Caddy Mk1 LT 1st generation...
in stock
Bracket for distributor, fits 30 hp engine
fits for 30 hp engine Beetle Karmann Ghia Type 14 Bus T1 older stock with traces of storage without bolt, nut and washers Overview of manifold holders 24,5 PS = 919 251 30 PS= 111 905 251 from 34 hp= 113 905 250 Type 4= 021 905 250 Type...
in stock
Bracket for distributor, T2, Type 3, Type 34 & Type 181
fits for: T2 Type 3 Type 34 Type 181 Originalsparepart
in stock
Bracket for wash water container, fits Bus T2 (until 07/71), used
fits for Bus T2 (up to VIN 211 2300 000) original spare part, used few available
Bracket, Fog light and Reverse Light,All Car, Pair
This is a new accessory part must have for all cars. This fog light bracket is extended arm will fit on your bumper bracket and extend to sit nice above your bumper. You can also bit reverse light in the back on this bracket and can work...
in stock
in stock
in stock
bulb holder (1 pin) for indicator and tail light, suitable for various models (from 08/69)
fits for: Type 1, tail light (from 08/73 - VIN 113 2000 001) Bus T2, tail light (from 08/71 - VIN 212 2000 001) Type 3 Front indicator lamp (from 08/69 - VIN 310 2000 001) LT, tail light (1st generation) original spare part, NOS only few...
bulb holder (2 pin) for indicator and tail light, suitable for various models (from 08/69)
fits for: Type 1, tail light (from 08/73 - VIN 113 2000 001) Bus T2, tail light (from 08/71 - VIN 212 2000 001) Type 3 Front indicator lamp (from 08/69 - VIN 310 2000 001) LT, tail light (1st generation) original spare part, NOS only few...
in stock
Bulb holder with seal for rear side light
Was installed as standard on US models Base marker light with lamp holder for side reflector
in stock
in stock
BUS SPEAKER KIT, includes mounting bracket, speaker and attaching hardware. Fits Mid'55-1967
Durchmesser des Lautsprechers: ca. 15 cm 8 OHM
in stock
in stock
in stock
Button for indicator switch, fit for Beetles from 01/53-08/59 and T1 bus
Bitte wählen Sie oben die Farbe für diesen Artikel aus.
Cable harness 08/67-07/69
Diese Kabelbäume werden nach US-Spezifikationen hergestellt und können im Vergleich zu europäische Modellen Abweichungen aufweisen. Für europäische Modelle und Sonderausstattungen müssen somit entsprechende Änderungen oder Ergänzungen...
Cable harness 08/69-07/71
Diese Kabelbäume werden nach US-Spezifikationen hergestellt und können im Vergleich zum europäischen Modell Abweichungen aufweisen. Für europäische Modelle und Sonderausstattungen müssen somit entsprechende Änderungen oder Ergänzungen...
Cable harness 08/71-07/72
Diese Kabelbäume werden nach US-Spezifikationen hergestellt und können im Vergleich zum europäischen Modell Abweichungen aufweisen. Für europäische Modelle und Sonderausstattungen müssen somit entsprechende Änderungen oder Ergänzungen...
in stock
Cable tie for harness with fixing
Cable tie color: black length: 110 mm width: 10 mm bolt diameter: 5 mm diameter receptacle: 23 mmTemperature range from: -40 °C Temperature range up to: +85 °C Material: polyamide 6.6 Mounting type: with weld stud mount Shape: grid...
in stock
Cap for wiperarm
Made by WERK34 Caddy front 1.5-1.8 (incl. D) 10/82-07/92 Golf rear 1.1-1.8 (incl. D) 04/74-07/83 Golf/Jetta front 1.1-1.8 (incl. D) 04/74-07/83 K70 front 1.6-1.8 11/71-02/75 LT front 2.0-2.7 (incl. D) 04/75-06/82 Passat Estate rear...
in stock
Cap, washer bottle
fits for: Golf MK1 Golf MK2 Golf MK1 Convertible Jetta MK1+MK2 Scirocco MK1+MK2 Caddy MK1 Bus T3 Passat 32 B Made by WERK34
in stock
Capacitor for ignition distributor, suitable for various models
length of the cable approx. 43mm In the 60's several very similar capacitors were used. The main difference is the length of the connecting cable - but in function and size they are interchangeable. Therefore this capacitor can be used...
Capacitor for the "giant" distributors
fits for the following ignition distributors VJR 4 BR 25/1 ZV/PAU 4 R 1 ZV/PAU 4 R 2 ZV/PAU 4 R 4 ZV/PAU 4 R 5 ZV/PAU 4 R 6
in stock
Viewed