rear axle
Novelties
No results were found for the filter!
in stock
Rear wheel bearing inner spacer (swing axle)
Fitting Position: Rear Axle / Inner Axle: Swing Axle Diameter 1/Diameter 2: 30/43mm
Repair plate for spring seat on wishbone, fit for Bus T3
New lower spring seat to repair the wishbone. Allows to fix your rear rusty wishbone of a T3 and T4
in stock
Reparatursatz Gleichlaufgelenk passend für Modelle von 08/67-07/92
passend für: Bus ab Bj 68 - 91 Kübel ab Bj 08/73 411/ 412
in stock
Right-hand torsion bar, fits Bus T2 (up to 07/71)
length 610mm, Ø 26,2mm inside 44 teeth, outside 48 teeth fits for Bus T2 (up to VIN 218 220 000) Bus T2 (VIN 219 000 001 to 211 2300 000 - ambulance, fire department & vehicles with rear seats ex works) original spare part, NOS limited...
in stock
Screw for joint flange
suitable for: Bus T2 Bus T3 Bus T4 Bus T5 grade 12.9 M10x1,5 internal serration Made in Germany
in stock
Set of rear axle bearing cap screws
Set consists of 4 pieces, M10x35 Original part number is only used for comparison 311 501 325 fit for Beetle from 57 and Karmann from 57 Type 181 08/69-02/73 Bus T1 to 07/67
in stock
Shaft seal to drive shaft, fits for bus T2 08 / 68-07 / 75
fits for right or left. Not suitable for automatic. OEM Made in Germany
in stock
Shaft seal to drive shaft, fits for bus T2 from 08/75 and T3
Fits for right or left Not for automatic OE quality Made in Germany
in stock
Torsion Arm Cover Bolt, M10x18 wrench size 15, year 08/59 on
the right screw with a 15 mm wrench size
in stock
Torsion bar left, reinforced, fits Bus T2 (from 08/71)
length 610mm, Ø 28.9mm for load transport vehicles fits for T2 bus (from 212 2000 001 - panel vans, estate cars, platform trucks & double cabs) original spare part, NOS with traces of storage limited quantity
in stock
Torsion bar, reinforced, fits Bus T1 (from 03/55)
length 590mm, Ø 29mm marked with white ring fits for Bus T1 (with M 140, fire truck) original spare part, NOS limited quantity
in stock
Wishbone, rear left, fits for Bus T3
Wishbone rubber bearing included fits for: Bus T3, all (except 16 inch Syncro) New part Installation tip: treat the control arm before installation with cavity sealant (eg Mike Sander)
in stock
Wishbone, rear right, fits for Bus T3
Wishbone rubber bearing included fits for: Bus T3, all (except 16 inch Syncro) New part Installation tip: treat the control arm before installation with cavity sealant (eg Mike Sanders)
Viewed