Pushrod rod oversize, to fit 25 and 30 hp engines

Pushrod rod 24.5 and 30 hp

fits:

• Beetle 25 and 30 hp engines
• Karmann Ghia 30 hp engines
• Type 147 Fridolin 30 hp engines
• Bus T1 25 and 30 hp engines (up to engine no. 3 399 999)
• Type 82 Kübelwagen

Product details:

• Outer diameter 15.00
• Total length 32 mm
• Original spare part, NOS (may show signs of storage due to long storage)
• Limited quantity

Installation instructions:

• Adjust the guide plates for the pushrod rods. The pushrod rods must slide under their own weight when oiled and, when attempting to turn them back and forth, should only exhibit a barely noticeable amount of play (0.01-0.02 mm).
• Do not twist the guide plates when adjusting, as this will cause the pushrod rod ends to run at an angle on the cams. (Noise, increased wear)
• If tappet noise occurs due to lateral play, the pushrod rods can be replaced with oversized ones.
  To avoid confusion, the pushrod rods must be marked or stored appropriately for final installation.