Bus T2 - generators | alternators
Novelties
No results were found for the filter!
in stock
108mm Dynamo/Alternator Top Pulley “C” Spanner
This “C” Spanner has been made to fit top pulleys with a diameter of 108mm, hooks into the notch on the rear of the pulley and holds it firm while the nut is undone or tightened up.
in stock
95mm Dynamo/Alternator Top Pulley “C” Spanner
This “C” Spanner has been made to fit top pulleys with a diameter of 95mm, hooks into the notch on the rear of the pulley and holds it firm while the nut is undone or tightened up.
in stock
99mm Dynamo/Alternator Top Pulley “C” Spanner
This “C” Spanner has been made to fit top pulleys with a diameter of 99mm, hooks into the notch on the rear of the pulley and holds it firm while the nut is undone or tightened up.
AC motor with 3 connector, for external control, overhaul in exchange, old part delivery after receipt of the product
The old deposit of 50.00 EUR is included in the purchase price and will be refunded upon exchangeable old part.
in stock
Air ellbow for alternator (55 A), 74-79
with clamp for vehicles with 55A alternator fits for Bus T2 (1.8-2.0) Type 4 original spare part, NOS limited quantity
in stock
Alternator Belt, Golf II / Jetta, 10x965 mm
MODEL ENGINE YEAR Golf/Jetta 1.6D 08/83-10/91 VW T.2 1.7-2.0 08/71-04/79 VW T4 2.0 09/90-07/95
in stock
Alternator conversion kit, fits for Beetle, Bus T1
this kit includes; alternator with built-in voltage regulator alternator bracket tie-down strap set of three backing plates fits for: Beetle, except 25+ 30 hp The pulley 903 111 109 A suitable for 105 mm alternators is also required
in stock
Alternator key with 21mm and 36mm wrench size
36mm at one end and 21mm at the other end (21mm is for the later alternator nuts) Fan pulley wrench, much smaller and lighter than a full size 36mm wrench. This key is made of robust tool steel and galvanized.
in stock
Alternator/dynamo back plate set
fits for 34 to 50hp type 1 engines for alternator or dynamo with 105mm diameter consisting of inner and outer plate for fan housing and stiffening flange spare part numbers for comparison 131 119 259, 131 119 261 & 131 119 271
in stock
Ball bearing for dynamo, fits various types
fits for armature of all DC alternators two pieces required per dynamo
Ball bearings for alternator, fit for various types
passend für Anker aller Gleichstrom-Lichtmaschinen zwei Stück pro Lichtmaschine erforderlich
Belt pulley for dynamo, fits Bus T2 (from 08/68)
for dynamos 211 903 031 D & 211 903 031 E fits for Bus T2 (from FIN 219 2000 001) Type 181 (M 63) original spare part, NOS only few available
Brush holder plate for alternator, fits Type 4 & Bus T2 from (03/69)
for alternators 021 903 023, 021 903 023 A, 021 903 023 B & 021 903 021 F fits for Type 4 Bus T2 original spare part, NOS single item
in stock
in stock
Deckel für Lichtmaschinen-Abdeckblech, passend für Typ 4-Motoren
passend für Bus T2 mit 1700ccm- bis 2000ccm-Motor Typ 4 Original-Ersatzteil, NOS wenige vorhanden
in stock
Deep groove ball bearing for alternator, fits various models
made in Germany fits for type 1 and type 4 engines WBX and diesel engines with 45A or 65A three-phase alternator spare part numbers for comparison: 021 903 221 A & 021 903 221 E
in stock
Double ended Dynamo / Alternator pulley spanner will fit the 99mm and 108mm pulleys
This tension wrench for the upper pulley of the alternator can be used to loosen and fasten 6 V and 12 V pulleys can be loosened and tightened. It hooks into the notch on the back of the pulley and then holds it in place while you want...
Drehstrom-Lichtmaschine 55 Ampere, passend für 1,7/1,8/2,0 bis 07/79
endlich können wir wieder eine neue Lichtmaschine für Ihren VW Bus T2 in Neu zu einem günstigen Preis anbieten die aber trotzdem eine gute Qualität bietet.
NEW
in stock
Drehstrom-Lichtmaschine generalüberholt im Austausch, passend für Typ 4-Motoren
55 Ampere passend für Typ 4 Bus T2 (außer M 618) Die Altteil-Kaution in Höhe von 50,00 EUR ist im Kaufpreis enthalten und wird bei tauschfähigem und gereinigtem Altteil erstattet. Altteil-Anlieferung nach Erhalt des Produktes...
in stock
Druckfeder für Kohlebürste, passend für Typ 4 & Bus T2
passend für Drehstrom-Lichtmaschinen 021 903 023 A & 021 903 023 F , die bei Typ 4-Motoren verwendet wurde Original-Ersatzteil, NOS wenige vorhanden
in stock
Electronic controller for DC lighting machine, 12 volts, Bosch
under the rear seat or in the engine compartment
in stock
Generator
originale Bosch Gleichstromlichtmaschine passt bei Bus T1 & 2 mit Typ 1 Motor bis 08/79, Käfer, Karmann Typ 14 und Kübel wir empfehlen auf jeden Fall einen neuen Regler, da wenn der Regler auch defekt ist kann er die neue Lichtmaschine...
in stock
Grommet for alternator/wiring harness, fits for Bus + Golf
Grommet for alternator/wiring harness fits for: Alternator cable: Bus T2, 1.7-2.0, 08/71-07/79 Wiring harness: Bus T3, 1.6-2.0, 05/79-07/92 Bus T4, 1.8-2.8, 09/90-06/03 Golf MK1, 1.0-1.8, 08/80-08/83 Golf MK2, 1.0-1.8, 08/83-07/92
Grooved ball bearing for alternator, fits various models
fits for Type 1, Type 4 & CT/CZ engines WBX and Diesel engines with 45A or 65A alternator original spare part, NOS single item spare part numbers for comparison: 021 903 221 A & 021 903 221 E
in stock
Inspection cover for dynamo with 105mm diameter
fits for the following dynamos: 113 903 031 G / 113 903 031 K / 113 903 031 M / 113 903 031 P & 113 903 031 Q
in stock
Interference suppression capacitor for alternator, fits Bus T2 & Type 4
fits for Type 4 Bus T2 (1700 to 2000ccm) original spare part, NOS single item
in stock
Kabelbaum für die Lichtmaschine, passend für Bus T2
Kabelbaum für die Lichtmaschine passend für: Bus T2, Typ-4-Motor, bis 07/79 Originalanwendung ab 08/77-07/79 bei Fahrzeugen bis 07/77 ist das schwarze Kabel für den Diagnosestecker nicht enthalten
Nabe des Kühlgebläserades, für Typ 1-Motoren
passend für Käfer Karmann Ghia Typ 147 Fridolin Bus T1 Bus T2 (bis FIN 218 220 000) Typ 181 (außer M 63) Original-Ersatzteil, NOS ersetzte Mitte der 60er Jahre 111 119 123
in stock
Plusdiode für Drehstromlichtmaschine, passend für Typ 4 & Bus T2
passend für Drehstrom-Lichtmaschinen 021 903 023 , 021 903 023 A & 021 903 023 F , die bei Typ 4-Motoren verwendet wurde Original-Ersatzteil, NOS Einzelstück
in stock
Pulley alternator chrome, 105 mm diameter
suitable for 6 Volt + 12 Volt DC Lima as well as for three-phase Lima
in stock
Pulley for alternator, for engines (from 08/65)
for 6 & 12 Volt for 105mm dynamos & three phase alternators fits for Beetle (from VIN 116 000 001) Karmann Ghia (from VIN 146 000 001) Type 147 (from VIN 146 000 001) Bus T1 (from FIN 217 000 001) Bus T2 (1300 & 1600cc) Type 181 spare...
in stock
Reparatur Kabel für Regler/ Lichtmaschinen Anschluss
Länge 12,5 cm Kabelquerschnitt 4mm² Kabelschuh Innendurchmesser 5,1 mm Ø wenige verfügbar
in stock
Riemenscheibe für 2. Drehstrom-Lichtmaschine, passend für Bus T2 & Typ 181
für Fahrzeuge mit M 51 passend für Bus T2 Typ 181 Original-Ersatzteil, NOS nur wenige vorhanden
Riemenscheibe für Drehstrom-Lichtmaschine, passend für Typ 4 & Bus T2
passend für Lichtmaschine 021 903 031 E , die bei Typ 4-Motoren verwendet wurde Original-Ersatzteil, NOS nur wenige vorhanden
in stock
Rotary Current Generator, 55Ah
suitable for: Beetle Bus Karmann Ghia Type: Beetle 1200 1.2 (11) Beetle 1303 (13) Beetle 1600 i (Mexico) Beetle Cabriolet (15) Transporter T2 Notes: 55Ah Power in KW: 25,32,34,35,37 Version: without pulley, with B + screw on the housing,...
in stock
Rubber stub, alternator 55A, 71-74
With clamp for vehicles with 55A alternator Bus T2 1.7-1.8, 08/71-07/74 (CA, CE, AP)
in stock
Rubber stub, alternator 70A, 74-79
With clamp for vehicles with 70A alternator Bus T2 1.8-2.0, 08/74-07/79
in stock
Seal for alternator housing, fits type 4-alternators
fits for Type 4 Bus T2 original spare part, NOS few available per vehicle two pcs. are needed
Viewed