Bus T1 - electrical
Novelties
No results were found for the filter!
in stock
Battery Cover 240 x 170 mm
Please compare the measurements with your battery. 240 x 170 mm Made by WERK34
in stock
Battery cover, fits Bus T1 (03/55 to 07/66)
approx. 170mm x 245mm for 77Ah- and 88Ah-battery fits for Bus T1 (VIN 20 - 117 902 to 216 190 000) Beetle (from VIN 1 - 929 746; M 67) nice reproduction
in stock
Bearing pin for starter, fits various models (02/55 to 12/69)
für die folgenden Anlasser 211 911 021, 111 911 021 D, 113 911 021 A, 111 911 021 F & 111 911 023 A fits for Beetle (VIN 2 528 668 to 119 1200 000) Karmann Ghia, Type 14 (VIN 2 528 668 up to 149 1200 000) Type 147 (up to VIN 149 1200...
Bearing shield for 6V dynamo, fits various models
blower wheel side fits the following dynamos 211 903 021 113 903 021 A 113 903 021 C original spare part, NOS with light storage traces few available
in stock
Bearing shield for 6V starter, fits various models (02/55 to 07/67)
with terminal clamps for the following 6V starters 211 911 021, 111 911 021 D, 113 911 021 A & 111 911 021 F fits for Beetle (VIN 2 528 668 to 117 999 000) Karmann Ghia, type 14 (VIN 2 528 668 up to 147 999 000) Type 147 (up to VIN 147...
Bevel washer, starter, 6V
Bevel washer behind the starter pinion Bettle, Karmann Ghia 12/56-07/66 Bus T1 12/56-07/66 Type 3 12/56-07/66
in stock
Bilux Bulb for asymmetrical Headlights 12V
Karmann, Bus, please indicate how many watts the bulb has got or where the bulb is used for.
in stock
Bolt for 90mm Ø dynamo housing, fits various models
fits for alternator with 90mm diameter Bus T1 Beetle Karmann Ghia type 14 Fridolin type 147 original spare part, NOS few available
in stock
Bracket for distributor, fits 30 hp engine
fits for 30 hp engine Beetle Karmann Ghia Type 14 Bus T1 older stock with traces of storage without bolt, nut and washers Overview of manifold holders 24,5 PS = 919 251 30 PS= 111 905 251 from 34 hp= 113 905 250 Type 4= 021 905 250 Type...
in stock
Bracket for fuse box, fits various models (from 05/60)
fits for Beetle (VIN 3 192 507 to 111 2799 842) Karmann Ghia (VIN 3 192 507 up to 140 3100 000) Bus T1 (from VIN 614 456) Type 147 Type 181 Brasil T1
Bracket, Fog light and Reverse Light,All Car, Pair
This is a new accessory part must have for all cars. This fog light bracket is extended arm will fit on your bumper bracket and extend to sit nice above your bumper. You can also bit reverse light in the back on this bracket and can work...
in stock
Breaker plate with contacts, fits for Garbe-Lahmeyer distributor
fits for the following ignition distributors 113 905 205 B / 113 905 205 J installed in Beetle Karmann Ghia type 14 Type 147 Bus T1 original spare part, NOS single item
Breaker plate with contacts, fits for Garbe-Lahmeyer distributor
fits for the following ignition distributors 113 905 205 L installed in Beetle Karmann Ghia type 14 Type 147 original spare part, NOS single item
in stock
Brush holder plate for starter motor
for 12V Bosch starter please compare with existing brush holder plate Original part number for comparison: 311 911 209 A original spare part, NOS only few available
in stock
in stock
in stock
in stock
in stock
in stock
Bulb holder for front indicators, fit for various models (up to 07/63)
passend für: Käfer (M 22; bis 1 600 439) Karmann Ghia Typ 14 (bis FIN 2 103 014) Bus T1 (FIN 614 456 bis 1 144 282) Original-Ersatzteil, NOS Einzelstück
Bulb kit 6V with a duplo headlight bulb
Bulb kit 6V with a duplo headlight bulb fits for: all models 08/60 and later The 6-volt bulb kit shown here consists of the following parts, one piece per piece: Duplo headlight P45t-41 (45/40W) Bayonet bulb BAY15d (20/5W) Bayonet bulb...
BUS SPEAKER KIT, includes mounting bracket, speaker and attaching hardware. Fits Mid'55-1967
Durchmesser des Lautsprechers: ca. 15 cm 8 OHM
in stock
Bushing in the gearbox for starter shaft, fitting for models up to 07/66, 6 volts
fitting for Beetle, Bus, Karmann Ghia and Type 3 up to 07/66 Inner diameter 12.5 mm Outside diameter 16.5 mm Originalpartnumber for comparison 111 301 155
in stock
Button for indicator switch, fit for Beetles from 01/53-08/59 and T1 bus
Bitte wählen Sie oben die Farbe für diesen Artikel aus.
in stock
Cable connector, 4-pin, fits for different vehicles
Cable connector for wide blade receptacles 6.3mm fits for: Beetle Karmann Bus Golf Porsche and many more vehicles
in stock
Cable for starter motor, fits various models
Lengths: red = 1050mm, black = 840mm Part numbers for comparison 311 971 225 C 311 971 228 151 971 228 B 141 971 225
in stock
Cable tie for harness with fixing
Cable tie color: black length: 110 mm width: 10 mm bolt diameter: 5 mm diameter receptacle: 23 mmTemperature range from: -40 °C Temperature range up to: +85 °C Material: polyamide 6.6 Mounting type: with weld stud mount Shape: grid...
Cancelling ring for turn signal at steering wheel, fits Bus T1 (from 05/60)
fits for Bus T1 (from VIN 614 456) Brasil T1 (until VIN BH 294 400 / April 1973) original spare part, NOS single item
in stock
Cancelling ring for turn signal at steering wheel, fits Bus T1 (from 05/60)
fits for Bus T1 (from VIN 614 456) Brasil T1 (until VIN BH 294 400 / April 1973)
in stock
Cap nut for starter protection cap
fits for following starters 311 911 021 113 911 023 211 911 023 311 911 023 B 003 911 023 A 311 911 023 C original spare part, NOS only few available
in stock
Capacitor for ignition distributor, fits various models
fits for the following ignition distributors 113 905 205 B / 113 905 205 J / 113 905 205 L please note: length of the cable approx. 65mm In the 60's, several very similar condensers were installed. Their main difference is the length of...
in stock
Capacitor for ignition distributor, fits various models (08/54 to 07/60)
for ignition distributor 111 905 205 C & 111 905 205 F fits for Beetle (engine no. 1-695 282 to 3 912 903) Karmann Ghia (up to engine no. 3 072 319) Bus T1 (engine no. 20-0831 284 to 3 999 999) spare part number for comparison 111 905 295
Capacitor for ignition distributor, suitable for various models
length of the cable approx. 43mm In the 60's several very similar capacitors were used. The main difference is the length of the connecting cable - but in function and size they are interchangeable. Therefore this capacitor can be used...
Capacitor for the "giant" distributors
fits for the following ignition distributors VJR 4 BR 25/1 ZV/PAU 4 R 1 ZV/PAU 4 R 2 ZV/PAU 4 R 4 ZV/PAU 4 R 5 ZV/PAU 4 R 6
Carbon brush set (BOSCH) for many 12V starters
fits for many 12V starters from the mid 60s onwards Original part number for comparison: 311 911 215 A original spare part, NOS only few available
Viewed